The EP Greenhouse Gearbox is a compact and lightweight reduction gearbox with a gear reduction motor built-in limit switch system that’s suitable for assembly of a locally available electric engine. The Gearbox can be used in manually-controlled or climate-managed ventilation and display systems in greenhouses. The quick and easy-to-installEP Gearbox is certainly rainproof and windproof. The Gearbox has a high protection class (IP65) and can be used in an ambient temperature of 0-60 °C.

The low-noise Gearbox for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminium precision housing. The self-braking worm wheel tranny means that the drive shaft is definitely locked when the decrease gearbox isn’t running. The completely sealed reduction gearbox comes with an expansion chamber with a diaphragm to keep the gear essential oil at a minimal pressure under all situations, even at high temps. Thanks to the use of an growth chamber, the Gearbox could be installed in any position. There are no limitations, since there is no need for a bleed connect. The sealed reduction gearbox keeps the apparatus oil of the Gearbox in ideal condition for its entire operating life time. The Gearbox is suitable for discontinuous use, operating class s3-30%, with a maximum activation period of 25 minutes.

The Gear box reduction gearbox has an FT85 motor assembly flange, on to which a suitable IEC standard motor can simply be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off by the end positions. The limit switch system is installed within an built-in chamber and is definitely enclosed by an impact-resistant plastic material cover. The limit change system is obtainable and easy to adjust. The limit change system’s optimum switching range is definitely 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The Gearbox has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The Gearbox for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates can be found as accessories.

Optimum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in case of software of 4-pole electric motor.
Protection class IP65.
Can be used in ambient temps of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 a few minutes.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installation of IEC standard motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).