Energy UNITS FOR LIFT TABLE 1
Common Description
This power unit is developed solely for your tiny lift table,Consisting of higher stress gear pump, AC motor, multi-functional manifold, valves, tank, and so on. This power unit continues to be broadly used during the industry of logistic devices for example minifork lift, scissors lift and ariel doing work platforms. The lower-ing motion is controlled by the solenoid valve with the velocity controlled from the adjustable needle valve.
Electrical power UNITS FOR LIFT TABLE 2
General Description
This electrical power unit is made solely to the medium lift table, Consisting of hugely effecient gear pump, AC motor, multifunctional manifold, valves, tank, ect. The decreasing movement is actived by the solenoid valve as well as the speed controlled by the adjustable needle valve. Once the lift rises to a large positoin, however the energy supply is reduce, the lowering motion is managed from the guide override perform.
Energy UNITS FOR LIFT TABLE three
General Description
This energy unit is intended exclusively for the substantial lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The lowering motion is actived from the solenoid valve plus the pace controlled by a strain compensated flow handle valve.
Energy UNITS FOR LIFT TABLE four
Standard Description
This power unit is intended exclusively for the significant lift table, Consisting of extremely effecient gear pump, AC motor, multi-functional manifold, valves, tank, ect. The reducing motion is actived by the solenoid valve as well as speed managed from the adjustable needle valve. When the lift rises to a high positoin, but the electrical power supply is reduce, the reducing movement is managed through the manual override perform.
Special Notes
one. This energy unit is of S3 duty cycle, which could only perform intermittently and repeatedly, i.e. one minute on and 9 minutes off.
two. Clean the many hydraulic parts concerned before set up of the energy unit.
three. Viscosity on the oil shoud be 15~46 cst,which ought to also be clean and no cost of impurities.N46 hydraulic oil is proposed.
4. Oil transforming is needed following the initial a hundred operation hours,afterwards when each and every 3000 hours.
5. The energy unit shown is made to be mounted vertically.