FMM Kind Mill Couplings
The FMM Variety coupling consists of 1 standard flex hub, a single universal straight bored hub as conventional, two sleeves and one accessory kit. This coupling is provided with exposed bolts as typical. Shrouded bolts can be found upon request as a result of size 5.5.
Functions
For lengthy existence
Conventional 20° strain angle
Heat treated bolts for higher power
Corrosion resistant bolts and nuts for ease of servicing
Supplies parallel, angular misalignment and end float
Flex Half coupling interchangeable with market standards
Long Universal Hub provided to buyer specs with straight or tapered bores
Ordering Info
Application: Driver and Driven.
Type and size of coupling, horizontal, vertical etc.
Power: Motor horspower or torque necessity.
Velocity: Motor RPM or Driven RPM.
Distance concerning shaft ends (BSE).
Shaft sizes.
Taper per foot and length of taper if tapered bore is required.
Specify counterbore dimensions if sought after.
Submit a drawing if readily available.

FHDFS Type Floating Shaft Couplings
The FHDFS Type coupling consists of two flex-rigid couplings and one particular floating shaft. The coupling is supplied with the rigid hubs outboard unless of course otherwise specified. The coupling comes with exposed bolts only.
Attributes
Flex Hubs for prolonged lifestyle
Regular 20° pressure angle
Heat treated bolts for higher strength
Corrosion resistant bolts and nuts for ease of maintenance
Accommodates parallel and angular misalignment
Elimination of center assembly makes it possible for forease of maintenance with no repositioning machinery
Rigid hubs outboard will allow for larger shaft diameters
Intended for high-torque low-speed applications that occur in mill operations
Ordering Facts
Application: Driver and Driven.
Style and size of coupling, horizontal, vertical etc.
Power: Motor horspower or torque necessity.
Pace: Motor RPM or Driven RPM.
Distance in between shaft ends (BSE).
Connecting tools shaft sizes.
Specify which hubs are to be utilised to the tools (Rigid or Flex).
Rigid hubs are going to be made use of around the tools except if otherwise specified.
Length of floating shaft may perhaps affect max angular misalignment.