“H” CLASS Refuse Drag Chains is used for conveying sawdust,wood chips, pulp, Stainless Steel Chain garbage, tankage, ashes, and other abrasive spend through either wooden or steel troughs. Due to its large, wide opening region, “H” CLASS Refuse Drag Chain provides sizeable holding capacity when operated at moderate speeds.
The front face of every barrel is flat, providing a wide area to push material along the trough and also to keep carefully the chaim from riding over the top of the material. The rounded internal aspect of the barrel can be carefully shaped to create excellent sprocket contact. Sidebars are reinforced with wearing sneakers which provide both
additional wearing surface area and stiffening for the link. A vertical member on each sidebar assures added hyperlink rigidity and defends the pin from damage.
“H”CLASS Refuse Drag Chain comes in EVRT-POWER Promal or Duramal with a tensile power selection of 36,400 to 52,000 pounds. This tough working chain comes in a pitch selection of 5.000 to 8.000 inches. Each link is produced in accordance with manufacturer’s requirements and may be interchanged with links made by other chain producers. “H”CLASS Refuse Drag Chain comes in riveted construction just. Grease chambers, cored into each link’s barrel, keep grease which lubricates pins.
Wide faced sprockets, either of machined or cast steel, are recommended for”H” class Refuse Drag Chain operation. Links should be operate in direction of the closed barrel.