Air Cooled Water Chiller Method CZPT Water Chiller For Beverage

1. Eurostars air cooled water chiller main elements
(one)Fluid circuit
*Normal insulated stainless metal tank (unpressurized)
*Optional pressurized tank
*Tank contains fill port, drain valve, degree gauge, and level sensor
*Insulated, non-ferrous centrifugal pump and fluid circuit
*Fluid bypass safeguards pump from injury if chiller inlet and outlet are shut
*Fluid swap protects in opposition to reduced-circulation condition
*Potential to use glycol mixtures up to fifty%
(two)CZPT circuit
*CZPTd with higher-top quality resources following arduous brazing processes and conforming to CZPTs
*CZPTally friendly R407C refrigerant (R134A, R404A is optional)
*Refrigerant sight glass and filter-dryer
*Externally equalized thermostatic growth valve
*Substantial and low force switches
*Large and minimal pressure gauges
*High and lower force entry fittings for maintenance and troubleshooting
*Optional Hot Gasoline Bypass Valve for extremely correct management of outlet fluid temperature
*CZPT
-Airtight compressors (scroll, rotary, or reciprocating) chosen for dependability and performance
-Mounted on rubber isolators for noise reduction
-Scroll compressors are specially silent and can handle liquid return without harm
-3-phase versions are guarded against reverse rotation by an digital period keep an eye on
-Crankcase heater stops liquid slugging on commence-up
*EVAPORATOR
-Copper coaxial evaporators are particularly reputable when dealing with contaminated fluids
-CZPT steel, brazed plate evaporators are compact and highly successful
-Evaporators are protected against freezing by the microprocessor controller
*CONDENSER
-Aluminum fins about copper tube design is compact and extremely effective
-All-aluminum development eradicates the chance of galvanic corrosion 
-Epoxy-coated for corrosion resistance, even in intense environments(optional)
-Condenser fan motor consists of interior, self-resetting thermal protector
(three)CZPTAL PANEL
*CZPTd in compliance with CZPTs using identified factors
*CZPTtrical cupboard made of powder-coated galvanized steel
*Disconnect switch with doorway lock prevents obtain to panel when energized (optional)
*MICROPROCESSOR CONTROLLER
-Optimizes device performance and maintains fluid temperature
-CZPT and shows the fluid temperature
-Turns the compressor on and off while safeguarding towards limited biking
-Turns the pump and condenser fan on and off
-Safeguarded by a watertight protect
-Displays important functioning parameters and the subsequent alarm problems:
Large and low refrigerant stress
Lower fluid differential pressure
Minimal fluid amount
Incorrect phase sequence
CZPT, pump, or admirer motor protector tripped
Temperature probe failure
Substantial fluid temperature
Evaporator anti-freeze
(four)Device CZPT
*Cabinet frame and panels are powder-coated and ideal for outdoor installation
*Panels are effortlessly taken out, delivering handy access for routine maintenance and repair
*All fasteners are stainless or zinc-plated metal for corrosion resistance
*CZPT to IP44 CZPT on 3-phase versions
*For relieve of installation all versions have lifting holes in the foundation small models with casters for movable
*Created for simplicity of procedure and maintenance

2. Eurostars air cooled industrial chiller characterisitics
(1)CZPT advanced Scroll compressor.
(2)CZPT steel water tank put in in the device(optional).
(3)Higher efficiency air condenser and Huge wind quantity axial stream design.
(four)Effortless to set up, dispense with cooling h2o pump.
(five)Large effectiveness, Minimal sounds centrifugal water pump.
(6)The device has far more refrigerating circuits.
(7)Small chiller has casters on chassis for simple manoeuvrability.
(8)Microelectronics manage.   

3. Air cooled industrial chiller apps
In industries as assorted as plastics production, metals finishing, pharmaceutical and chemical processing and dry cleansing, Eurostars has provided innovative options to some of the most demanding industrial procedure cooling issues.
From chillers that comply with rigorous food processing market restrictions to substantial-good quality extrusion bath recirculators, Eurostars industry answers keep paces with the evolving demands of your company.
Major CZPT Served:
(one)Machining and steel functioning
(two)CZPT and rubber
(3)Food and beverage
(four)Concrete cooling
(five)CZPT and laboratories
(6)Breweries and wineries
(7)Ease and comfort cooling
(8)Laser & Welding chillers

four. Eurostars air cooled industrial chiller short technological data 
Please ask salesman for detailed complete data or visit our website:

Air Cooled Chiller Unit
Model      ESSA-			01ISSN	02ISSN	03ISTN	04ISTN	05ISTN	06ISTN	08IDTN	10IDTN	12IDTN
Merchandise NO.			one	2	three	four	5	6	8	10	twelve
Rated CZPT Ability	KW		2.76	5.72	eight.96	eleven.31	14.12	17.24	22.62	28.24	34.48
	USRT		.78	one.63	two.55	3.22	4.02	four.90	six.43	eight.03	9.81
	×1000 kcal/h		2.37	4.92	7.71	nine.73	12.14	fourteen.83	19.45	24.29	29.65

Air Cooled Chiller Unit
Model      ESSA-			15IDTN	20IDTN	25IDTN	30IDTN		40IQTN	50IQTN	60IQTN
Product NO.			15	20	twenty five	30		40	fifty	sixty
Rated CZPT Ability	KW		43.22	fifty eight.two	seventy one.18	87.3	87.78	116.4	142.36	177.ninety five	a hundred seventy five.56
	USRT		12.29	16.55	twenty.24	24.83	24.97	33.11	forty.49	fifty.61	forty nine.93
	×1000 kcal/h		37.17	fifty.05	sixty one.21	seventy five.08	seventy five.49	one hundred.10	122.43	153.04	one hundred fifty.98

Remarks:
(1) Rated CZPT Potential Dependent on:Evaporating temperature 7ºCCondensing temperature 50ºC,Ambient DB=35ºC.
(two)Chilled Drinking water Assortment: five~25ºC

five. Eurostars air cooled industrial chiller defense products
(1)Motor overload protection
(2)CZPT motor overheat security
(three)Discharge temperature overhigh protection
(4)Large&low stress security
(five)Returning drinking water overheat protection
(6)Low water circulation/stage security
(7)Phase safety
(eight)Anti-freezing safety

six.CZPT Chiller Installation Precautions

Even though Eurostars provides chiller installation advice service, if you previously have some activities in chiller procedure and installation, you can choose to move forward by your self to preserve labor cost and time.
But pay out attention to a number of more specifics, the chiller will return you much better efficiency and longer provider daily life. 
Below are the safety measures that you want to know prior to commence:
(1)Selection of installation location.
For air cooled chillers,we require an open up space with very good ventilation. Make confident there is no limitations or walls inside 1m all around it, in any other case there will be difficulties for air flow and warmth dissipation. The position is we need to have to make sure the heat out from the chiller can be taken out outside the house, instead of circulating inside a small space.The distance to block also assures room for routine maintenance. If you are plHangZhou to put in an air cooled chiller in a space with bad air flow, you need to take into account mounting air duct on top of the chiller around the condenser enthusiasts, so to make confident warmth removing.

In underneath image, Case1 is a chiller positioned in drafty issue, Scenario two is a chiller found in inadequate air flow setting.

For water cooled chillers, we just require to reserve enough place for upkeep, as the heat from the chiller is removed via water to the cooling tower.
(2)Floor for locating the chiller.
 CZPT chiller have to be positioned on solid and level concrete flooring which is in a position to support the bodyweight of the chiller. The levelness of the flooring need to be inside 6mm. Chillers vibrate when running, if the ground is not reliable nor flat, the chiller will easily displace, specifically for transportable chiller with casters. Rough ground will amplify the vibration of chiller, which will lead to severe troubles after long time operating.
 
For a large chiller device, say types higher than ESSA-15IDTN, we need to develop concrete basis for it. It is needed to make 50-100mm absorbing gap fill with sands or pitch all around the foundation. On the foundation, there need to be bolt holes for fastening the chiller foundation and concrete basis with each other.
 
After the above things are done, let us set the chiller on the foundation. Then we need a amount meter to check out if there is any incline. If there is, place parallels amongst chiller base and concrete basis to change it.

(three)Pipe, wire and filter planning
*In a Eurostars chiller specification sheet, there is link dimension and max amps for the unit. Accurately pick the pipe and wire measurement by referring to it.
*If you are not so confident with the water good quality in your area, filtration is a requirement to steer clear of the chiller h2o circuit from difficulties.Y sort filter is advised.
*Make confident you are clear that which port you should connect to. Despite the fact that there will be indicator of inlet or outlet of every single Eurostars chiller, double examine it please.

 

seven. FAQ
Q: Can I have a sample for screening ahead of purchasing products?
A: Yes, you can purchase little chiller in the same sequence. And you are warmly welcomed to check out our manufacturing facility prior to PO.

Q: What is the guarantee of products?
A: Warranty: 12~24 months following Bill of Lading date. Any unartificial failure transpired in the period, we’ll provide you the spare parts for free, and everlasting technological assist & session all daily life prolonged for the equipment.

Q: How to effectively set up the chiller?
A: We have very comprehensive consumer manual and set up guidelines, also can be immediately telephone or on-line video clip guidance.

Q: How about your soon after-sale provider?
(a)Give customers with installation and commissioning on-line recommendations. And we also supply neighborhood whole undertaking installation.
(b) Effectively-skilled engineers available to overseas support.
(c) Around the world agents and soon after-sale support accessible.

Q: Do you test all your goods just before shipping and delivery?
A: Sure, we have 100% take a look at before delivery.

Q: How to deal with the faulty?
A: Our items are made in rigorous high quality handle system, but if any defective, we will ship new spare elements for free in 1 warranty year.

eight. Air cooled chiller VS Drinking water cooled chiller
(1)Air cooled chillers need less maintenance than water-cooled units.
(2)Air cooled chillers do not need a cooling tower or a condenser drinking water pump.
(three)Consume roughly 10% more electrical power than a water-cooled device thanks to damp surfaces transferring heat better than dry surfaces.

9. Eurostars Organization Ceritifcate & Consumer Going to
We, EUROSTARS, which set up in year 2006, is a modern hi-tech business, specializing in Heating Ventilation Air Conditioning and CZPT CZPT research, growth, generation, revenue and engineering companies.

Eurostars crew with more than 10 a long time expertise of CZPT tools and system in neighborhood China and global marketplace, has supplied qualified CZPT products, installation and service to thirty+ nations around the world all around the globe.

ten. Our factory look at
CZPT new method and assemble line, like copper tube straighten device, aluminum fin punching equipment, three dimensional copper tube bending device, tube expander machine, sheet steel laser cutting device, numerical control punching machine, CNC bending equipment, chiller, fan coil unit and AHU assemble line,. etc..

Chiller generation at our previous location as beneath

10. Eurostars air cooled industrial chiller package and delivery
Our CZPT deal is plastic movie with plywood circumstance for protected shipping and delivery and simple to load/unload.

11. Eurostars industrial chiller assignments
We exported chillers to Ukraine, New Zealand, Guatelmala, Peru, Chile, Norway, Serbia, CZPTia, Greece, France, South Africa, Australia, Uzbekistan, Sri Lanka, India, Saudi Arabia, Iran, Mexico, Argentina, etc..