The EP Greenhouse gear driver is a compact and lightweight reduction reducer with a limit switch system that’s ideal for assembly of a locally available electric motor. The reducer is utilized in manually-controlled or climate-controlled ventilation and screen systems in greenhouses. The quick and easy-to-install EP gearbox is rainproof and windproof. The gear driver has a high protection course (IP65) and can be used within an ambient temperature of 0-60 °C.

The low-noise gear motor for Greenhouse has a gearwheel transmission and a worm wheel transmission, which are integrated in an aluminum precision housing. The self-braking worm wheel transmission means that the drive shaft is usually locked when the decrease gear reducer is not running. The fully sealed reduction gear reducer has an expansion chamber with a diaphragm to keep carefully the gear essential oil at a low pressure under all conditions, even at high temperatures. Thanks to the use of an expansion chamber, the gear driver can be installed in any position. There are no restrictions, because there is no need for a bleed plug. The sealed reduction gear reducer keeps the gear oil of the gear motor in ideal condition because of its entire operating life time. The gearbox is ideal for discontinuous use, working course s3-30%, with a maximum activation time of 25 minutes.

The Gear box reduction gear motor has an FT85 motor assembly flange, to which the right IEC standard motor can easily be installed (EN 50347).

The Gear box has a rotating limit switch system with operating switches and circuit breakers (NC contacts) for turning off at the end positions. The limit change system is installed in an built-in chamber and is certainly enclosed by an impact-resistant plastic cover. The limit switch system is obtainable and easy to adjust. The limit change system’s optimum switching range can be 40 or 64 revolutions of the drive shaft. The cabling is linked in spring-clip connections. The gearbox has an IP68 M16 x 1.5 cable gland (5-9 mm cable) for the cable feed-through.

The gearbox for greenhouse comes with 16 teeth 5/8”x3/8” sprockets, keys and fasteners. The accompanying chain couplings and assembly plates are available as accessories.

Maximum drive torque of 150 Nm or 450 Nm.
Rotational speeds of 3 or 5 rpm for a mains frequency of 50 Hz or 3.6 or 6 rpm for a mains frequency of 60 Hz in the event of program of 4-pole electric motor.
Protection class IP65.
May be used in ambient temps of 0-60°C.
Suitable for discontinuous use, operating class s3-30%, maximum activation time 25 minutes.
Equipped as regular with 16-tooth galvanised chain coupling 5/8″x3/8″.
FT85 motor assembly flange for installing IEC regular motor (EN 50347).
Maximum switching selection of limit switch program 40 or 64 revolutions of the drive shaft.
IP68 M16x1.5 cable gland for cable feedthrough (5-9 mm cable).