Spiral bevel gears are typically made from hardened steel. The teeth of these gears are often ground for a more precise finish allowing for little noise at high speeds. You can specify left hands or right hand based on the direction you should run the gears

If you have a higher speed application that requires a whole lot of torque then spiral bevel gears are a great option. The gears operate at 90° to each other and have “spiral” shaped teeth which gives maximum tooth surface get in touch with while rotating. With get in touch with spread over the whole tooth the spiral bevel equipment could be run much quicker compared to the straight tooth bevel gear and handle harder starts and stops.

We make spiral bevel gears limited to industrial applications.

Worm gears are found in large equipment reductions. Gear ratio ranges of 5:1 to 300:1 are standard. The setup was created to ensure that the worm can change the gear, however the gear cannot change the worm. The position of the worm can be shallow and because of this the gear is held in place because of the friction between your two. The gear is situated in applications such as for example conveyor systems in which the locking feature can become a brake or an emergency stop.

The model cross-section shows an average placement and usage of a worm gear. Worm gears have an inherent spiral gear china safety mechanism built-in to its style given that they cannot function in the reverse direction.